Spindle
cutter - Glue joint (single F-joint)
Tungsten Carbide - 3 wing
The cutter is designed to be used with a stationary spindle moulder equipped with either a 3/4' or 1/2' spindle shaft.
The cutter is a counter-profile cutter. When properly aligned, it will allow two panels to join together without the use of a secondary cuttter. The F-profile assists with alignment during assembly and adds a greater glue surface, resulting in a stronger joint.
KP800020 - 3/4' - 1/2' spacer rings
Important:
- Make sure the spindle moulder has a table opening of at least Ø
140mm.
- Designed for spindle moulders equipped with either a 1/2' or 3/4'
spindle shaft.
consider
safety for your health and the people around you |
General safety suggestions:
It is advisable to always have the following items nearby and in a good
condition
- Eye protection clean and scratch free
- Hearing protection quality earmuffs
- Dust masks discard old and dirty masks
- Gloves for easy handling of material and hand protection
|
|
|
|
|
Wear Gloves
|
Eye Protection
|
Hearing Protection
|
Dust Mask
|
To use spindle cutters safely (and to get the best results from your spindle), the
cutters need to be installed properly on the spindle shaft. Improper installation
of your cutter can cause excessive chatter and could increase the likelihood that
the bits will break when in use. There is also a risk of having the cutter 'cold welded' to the spindle shaft.
First of all, before beginning any moulding operation, check your cutter to
make sure that it is clean and most of all, sharp.
If the bit is dull, chipped, is excessively burnt or has any other defect,
it should be sharpened or replaced before use.
Description |
Specification |
Cutter profile |
Glue joint (single F-joint) |
Arbor |
3/4' |
Wings |
3 |
KP19Router Bits > Spindle Cutters