PRO-TECH FLUTE BIT 7/8' x 1/4' RADIUS 1/8' 1/4'SHANK KP332011

Flute Bit

Carbide Tipped

• Cut individual flutes-shallow, small-radius grooves-in narrow edges without having to balance a router on the edge.
• Cut flutes on the edges of curved pieces.
• The bit cuts at right angles to the bit axis
• Flute depth is controlled by the pilot bearing, the flute's position by the router's bit-height setting
• 2-Flute, industrial quality & carbide tipped

 

 

PRO-TECH router bits are manufactured in Taiwan.

 

consider safety for your health and the people around you
General safety suggestions: It is advisable to always have the following items nearby and in a good condition Eye protection clean and scratch free Hearing protection quality earmuffs Dust masks discard old and dirty masks Gloves for easy handling of material and hand protection
Wear Gloves	Eye Protection	Hearing Protection	Dust Mask

Router Table Safety

Although most router bits are small, they can be potentially dangerous and should deserve your attention and respect.

1 Use push sticks or a push block to position your hands a safe distance from the router bit.

2 Use large-diameter bits only in a router table. Using bits over 25mm Ø (diameter) in a handheld router can possibly cause you to lose control of the tool and harm yourself or bystanders.

3 Always wear a dust mask as well as eye and hearing protection.

4 Take light cuts. Heavy cuts invite kickback. If necessary, move the fence closer to the bit or switch to a larger guide bearing/bush.

5 Use a featherboard (anti-kickback device) to support the workpiece against the router table and/or fence.

6 Never climb-cut. Always feed the stock from right to left. Against the rotation of the router bit. (see illustration)

7 Avoid routing small stock. Instead, rout a larger piece and cut it to size afterwards. If you absolutely have to profile a small piece, build an suitable jig or secure the workpiece.

8 Always use a guard. If the fence didn t come with a guard, make your own.

9 Never start the router with the bit in contact with the material.

10 Don t force the router bit or overload the router. Excessive heat is an enemy.

11 Secure/fasten the router in the base before starting/switch on the router.

12 Don t bottom out the bit in the collet or partially insert the bit. Instead, completely insert the bit, and then back off approximately 2 mm. At least ²/₃ 's of the router bit shank should be inside the collet.

13 Be sober and not under the influence of medicine that causes a lack of concentration

14 Tidy up your workshop to ensure the ability to move freely with enough room around the router table

Part No.	Shank dia.	Cutting width	Cutting Height	Radius (r)
KP332011	1/4 inch	7/8 inch	1/4 inch	1/8 inch
	6,35 mm	22,2 mm	6,35 mm	3,2 mm

 

Length of Shank: 32 mm
Replacement bearing: KP100 5-8

 

 

---

KP332011Router Bits > Fluting/Beading > Flute